The following precautions should be taken when cleaning a woodworking carving machine:

1. Ensure that the device is turned off and unplug the power. Avoid directly touching any part of the machine, wires, or connectors. 2. Use a soft bristled brush or targeted weak solvent cleaner to remove accumulated materials and grease, rather than using a harder fabric or other tool to clean the body to avoid scratching it. 3. Choose the appropriate liquid for rinsing as needed and ensure moderate water pressure to prevent the surface treatment layer from peeling off due to excessive impact force. 4. Do not spray repeatedly at the same location to eliminate sediment, as this may cause damage to the circuit board. 5. During the drying process, please turn off the laser device to ensure safety. After installation, perform self inspection to confirm that there are no factors affecting safety before running. Note: Do not use corrosive chemicals or organic reagents such as alcohol to scrub chemical engraving and printing materials. Use water-based pens to trace and gently wipe with alcohol diluent to avoid damaging the desktop; If it is steel furniture, metal rust remover and corresponding towels need to be used to gently wipe back and forth to prevent scratches. 8. Pay attention to protecting the motor parts and their circuit joints from water and moisture. The specific situation of each device is different. When operating, it is necessary to adapt to local conditions, otherwise it will cause unnecessary trouble. The above is the content about how to effectively maintain the wood carving processing center correctly. I hope it is helpful to you! These precautions can help you maintain and use your woodworking carving machine more effectively. If you have more questions or want to learn more detailed information, you can consult our professional services!