The operation process of the vibration engraving machine is as follows:

1. Connect the power supply and turn on the machine switch. At this time, attention should be paid to whether the voltage and current of the equipment are consistent with the nameplate.

2. Select the mode as needed (such as metal or non-metal processing) and set the corresponding parameters. Note that these values may need to be adjusted appropriately based on different materials, tool heads, and quality requirements.

3. Fix the workpiece on the fixture and press the bottom of the cutting blade against the working surface with slight movement to ensure complete contact. Then, fine tune the screws to control the stability of the amplitude. Generally, according to empirical rules, it is set between 0.5 and 8mm. For some fine operations, smaller values may be required. At the same time, attention should be paid to avoiding the phenomenon of empty hits. Ensure that there is no air or other substances present in the gaps between moving parts, otherwise it may cause equipment damage or reduced efficiency. 4. Start running the program and inspect the finished product to ensure accuracy and achieve the expected goals; If errors occur, calibration and repair can be carried out based on feedback data to achieve normal working conditions. Close all software/applications and motors to make the saw blade stationary before removing the sheet from the rack.. In the actual use process, it is necessary to adjust and improve according to the actual situation to obtain the user experience and benefits.

The above content is for reference only. Please refer to the product manual for details. Please strictly follow the instructions for correct operation to avoid causing damage to the equipment and yourself, affecting the normal use cycle and work quality!