& nbsp; When using a stone carving machine, cutting tools are definitely indispensable, which means that cutting tools are very important for the stone carving machine. In addition, the installation of cutting tools for stone carving machines is also very important. If the installation is not correct, it will affect the use. The most important indicator of the quality of stone carving machines is accuracy. The higher the accuracy, the more powerful the manufacturer is. After unremitting efforts, the technology of Gongda Stone Carving Machine can now fully achieve any precision for customers.
  & nbsp; If the cutting tools of the stone carving machine are installed correctly, the carved patterns can be more accurate, and the tools are not easily broken during use. How to quickly and correctly install the cutting tools of the stone carving machine?
  There are many gaps on the chuck. Before clamping the tool, it is necessary to clean the chuck with gasoline or WD40 cleaning agent, and check and remove the residue in the gaps of the chuck;
  2. The fit between the chuck and the shaft relies on the contact of the tapered hole at the end of the shaft. If the contact is not good, the tool is not easy to install correctly. It is necessary to ensure good contact between the tapered surface. Before cutting, the conical surface of the shaft must be cleaned with gasoline or WD40 cleaning agent;
  3. Place the clamp into the pressure cap, gently rotate the clamp spring, and wait for the eccentric part of the pressure cap to be recessed into the clamp groove. Apply even force to push the clamp in the direction of the arrow to install it into the pressure cap;
  4. Install the chuck and pressure cap together on the spindle of the machine tool. Clean the cylindrical handle of the tool and insert it into the clamping hole. After confirming that the chuck and tool are aligned, screw the pressure cap into place by hand. Use a wrench to evenly tighten the pressure cap until the tool is firmly clamped before use;
  5. When loosening the tool, use a wrench to twist the pressure cap in the opposite direction. If you need to replace the chuck, release the pressure cap to bring out the chuck and tool, remove the tool, and push the chuck in the direction of the arrow to push it out. Then, replace it with a chuck with a different aperture as needed.